General features

English

“Bass EXT” : Switch the Bass Extend mode on/off. Setting values: ON / OFF

(When the bass extend mode is set to on, low frequency response is extended by 20%.)

NOTE

This mode is available only when the Sound coordinate system is on. (page 36)

“Tre Frq” : Adjust the centre frequency of the treble. Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHz

NOTE

This mode is available only when the Sound coordinate system is on. (page 36).

“Tre” : Adjust the treble level.

Setting values: - 8 – + 8

“Balance” : Adjust the balance level. Setting values: Left 15 – Right 15

“Fader” : Adjust the fader level. Setting values: Front 15 – Rear 15

“NFpre Level” : Adjust the Non-fading output level. Setting values: - 15 – + 15

NOTE

•This mode is available only when the non-fading output function is set to on. (KDC-8080R only)

•Not available during the Dual zone system is on.

“HPF Front” : Adjust the frequency of the High-pass filter for front output.

Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / 150Hz / 180Hz / 220Hz

NOTE

You can separately set the high-pass filter for front and rear output, including preouts. The high-pass filter works except during non-fading preout when switching to non-fading (KDC- 8080R only). The factory default settings for front output and rear output are "through" .

“HPF Rear” : Adjust the frequency of the High-pass filter for rear output.

Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / 150Hz / 180Hz / 220Hz

NOTE

You can separately set the high-pass filter for front and rear output, including preouts. The high-pass filter works except during non-fading preout when switching to non-fading (KDC- 8080R only). The factory default settings for front output and rear output are "through" .

— 14 —