1st section
[2] button
Adjustment Item Display Range
Bass Center
Frequency "Bass FRQ" 60/70/80/100 or 150 Hz
Bass level "Bass" –8 — +8
Bass Q Factor "Bass Q" 1.00/1.25/1.50/2.00
Bass Extend "Bass EXT" ON/OFF
5Select the Audio Control item for adjustment
Press the [2] — [5] button.
Each time the [2] [5] button is pressed the adjustable audio
items are switched among ranges of all stage section's tables on
the following pages.
6Adjust the Audio Control item
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
7Exit Audio Control mode
Press the [RTN] button.
The loudness setting can also be adjusted by pressing the [4]
button.
WOW can be set when SRS WOW or User memory is selected at
<System Q> (page 10).
* This mode is available only when <Non-fading Output> (page
18) is ON.
The Loudness can not be set when SRS WOW is selected at
<System Q> (page 10).
— 11 —
[3] button
Adjustment Item Display Range
Middle Center
Frequency "MID FRQ" 0.5/1.0/1.5/2.0 kHz
Middle level "MID" –8 — +8
Middle Q Factor "MID Q" 1.0/2.0
[4] button
Adjustment Item Display Range
Treble Center
Frequency "TRE FRQ" 10.0/12.5/15.0/17.5 kHz
Treble level "TRE" –8 — +8
[5] button
Adjustment Item Display Range
Balance "Balance" Left 15 — Right 15
Fader "Fader" Rear 15 — Front 15
According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
When the bass extend is set to ON, low frequency response is
extended by 20%.
KDC-9023R_U.S_r4.pg 02.12.9 6:02 PM Page 11