— 55 —
?There’s no Front High Pass Filter and Rear High Pass Filter effect.31
✔The Non-fading preout is being used.
☞There’s no effect in Non-fading preout.
?The Touch Sensor Tone doesn’t sound.34
✔The preout jack is being used.
☞The Touch Sensor Tone can’t be output from the preout jack.
?Even though Synchronize Clock is ON, the clock can’t be adjusted.35
✔The received RDS station isn’t sending time data.
☞Receive another RDS station.
?The Dimmer function doesn’t work. 38-1
✔The Dimmer wire isn’t connected correctly.
☞Check the Dimmer wire connection.
?The panel is not hidden even when the power is turned off. 38-3
✔The protection function for preventing fingers or other things from
getting caught in between the panel and this unit has been activated.
☞Turn off the power again.
?Sound is interrupted when Dual Zone System is set to ON.38-4
✔When Dual Zone System is set to ON while the Menu system’s <AF
(Alternative Frequency)> (page 43) is set to ON, the sound quality
may be adversely affected if the internal source is set to the tuner.
☞---
?There are no audio control effects.
✔WOW item on <Audio Control> (page 10) and SRS WOW item on
<System Q> (page 10) have no effect in rear output.
☞---
Tuner source
?Radio reception is poor.39
✔The car antenna is not extended.
☞Pull the antenna out all the way.
✔The antenna control wire is not connected.40
☞Connect the wire correctly, referring to the section on
<Connecting Wires to Terminals>.
?The desired frequency can’t be entered with the Direct Access
Tuning.41
✔A station that can’t be received is being entered.
☞Enter a station that can be received.
✔You’re trying to enter a frequency with a 0.01 MHz unit.42
☞What can be designated in the FM band is to 0.1 MHz.
?It isn't the set Traffic information sound volume. 43
✔The set sound volume is less than the tuner sound volume.
☞If the tuner sound volume is louder than the set sound volume,the
tuner sound volume is used.
Disc source
?"AUX1" is displayed without achieving External disc control mode.50
✔Unsupported disc changer is connected.51
☞Use the disc changer mentioned in the IMPORTANT
INFORMATION of the section on <Safety precautions> (page 3).
?The specified disc does not play, but another one plays instead.52
✔The specified CD is quite dirty.
☞Clean the CD.
✔The disc is loaded in a different slot from that specified.54
☞Eject the disc magazine and check the number for the specified
disc.
✔The disc is severely scratched.55
☞Try another disc instead.
?A CD ejects as soon as it is loaded.62
✔The CD is quite dirty.63
☞Clean the CD, referring to the CD cleaning of the section on
<About CDs> (page 5).
KDC-9023R_U.S_r4.pg 02.12.9 6:03 PM Page 55