English
— 52 —— 52 —
Accessory2
Removal tool
Screw (M4X8)
(commercially
available)
■Removing the Unit
4Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5Pull the unit all the way out
with your hands, being
careful not to drop it.
1Refer to the section <Removing the hard rubber frame> and
then remove the hard rubber frame.
2Remove the screw (M4 × 8) on the back side.
3Insert the two removal tools deeply into the slots on each
side, as shown.
Installation
Catch
Lock
Accessory2
Removal tool
■Removing the hard rubber frame
2When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
KDC-9023R_U.S_r4.pg 02.12.9 6:03 PM Page 52