— 51 —— 51 —
■Installing in Japanese-Made Cars
•To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
•The hollow at the center of the rubber frame is designed to make it
easier to remove discs.
If you do not want the hollow to be visible, mount the rubber frame in
the opposite direction (with the flat side at the top instead of the
bottom).
8mm
5mm
5mm
8mm
For Nissan Car
Accessory4
for Toyota car Accessory3
for Nissan car
For Toyota Car
Damage to the unit will result from using screws other than
those provided.
Factory-installed
Radio Bracket
After aligning the factory-installed radio
bracket, tighten the screws.
KDC-9023R_U.S_r4.pg 02.12.9 6:03 PM Page 51