About the Cell-Phone

This unit conforms to the following Bluetooth specifications:

Version

Bluetooth Standard Ver. 1.2

Profile

HFP (Hands Free Profile)

 

OPP (Object Push Profile)

 

PBAP (Phonebook Access Profile)

 

SYNC (Synchronization Profile)

For the cell-phones verified for compatibility, access the following URL:

http://www.kenwood.com/bt/information/

⁄

•The units supporting the Bluetooth function have been certified for conformity with the Bluetooth Standard following the procedure prescribed by Bluetooth

SIG. However, it may be impossible for such units to communicate with your cell-phone depending on its type.

•HFP is a profile used to make a hands-free call.

•OPP is a profile used to transfer data such as a phone book between units.

About the Bluetooth Audio player

This unit conforms to the following Bluetooth specifications:

Version

Bluetooth Standard Ver. 1.2

Profile

A2DP (Advanced Audio Distribution Profile)

 

AVRCP (Audio/Video Remote Control Profile)

⁄

•A2DP is a profile designed to transfer the music from an audio player.

•AVRCP is a profile designed to control playback and selection of music by an audio player.

Menu Glossary

•SRC Select

Setting up the Source Select mode.

1 : Displays source icons for your choice.

2 : Allows you to select sources one after another.

•BT DVC Status (Displaying the Bluetooth device Status)

You can display the connection status, signal strength, and battery level.

: Bluetooth cell-phone connection status.

: Bluetooth Audio connection status.

: Battery level of cell-phone.

Full Nearly dead : Signal strength of cell-phone.

Maximum Minimum

⁄

•Icons are not displayed if information cannot be obtained from the cell-phone.

•Since the number of steps of the control unit is different from that of the cell-phone, the statuses displayed on the control unit may discord from those displayed on the cell-phone.

•Auto Answer (Setting the Time Interval for Automatic Answer)

This function automatically answers (responds to) a call after lapse of the preset time interval for automatic answer.

“OFF” : Does not answer the phone call automatically.

“0” : Automatically answers the phone call at once.

“1s” – “99s” : Automatically answers the phone call after lapse of 1 – 99 seconds.

⁄

•If the time set in the cell-phone is shorter than that set in the unit, the former will be used.

•This function does not work for call waiting.

•SP Select (Setting up the Voice Output Speakers)

You can specify the voice output speakers.

“Front” : Outputs voice from the front-left and front- right speakers.

“F-R” : Outputs voice from the front-right speaker.

“F-L” : Outputs voice from the front-left speaker.

⁄

•Select the speaker which is further from the microphone in order to prevent howling or echoes.

•Call Beep (Setting the Beep of the Incoming Call)

You can output a beep from the speaker when a call comes in.

“ON” : Beep is heard.

“OFF” : Beep is canceled.

•Display

If this unit is not operated at least 5 seconds with “OFF” selected, the display turns off. During a setup mode, the display will not turn off even if 5 seconds lapse.

•ILM Dimmer (illumination dimmer) Reduces the key Illumination brightness.

AUTO: Dims the illumination in conjunction with the Light switch of the vehicle.

MNAL1: Dims the illumination constantly.

MNAL2: Turns off the upper and lower illuminations, and dims the left and right illuminations.

OFF: Does not dim the illumination.

English 31