Kenwood KDC-BT7539U Range, Range, Display, Display, Audio Setup, Audio Control, 5Exit Audio Setup mode, 2Enter Audio Setup mode, Select the source to adjust

Audio Adjustments

Audio Control

You can adjust following Audio Control items ;

Adjustment Item	Display	Range
Rear volume	“REAR VOLUME”	0 — 35
Subwoofer level	“SUB-W LEVEL”	–15 — +15
System Q	“USER”/“ROCK”/	User setting/Rock/Pops/Easy/
	“POPS”/“EASY”/	Top 40/Jazz/Natural
	“TOP40”/“JAZZ”/
	“NATURAL”
Bass level*	“BASS LEVEL”	–8 — +8
Middle level*	“MIDDLE LEVEL”	–8 — +8
Treble level*	“TREBLE LEVEL”	–8 — +8
Balance	“BALANCE”	Left 15 — Right 15
Fader	“FADER”	Rear 15 — Front 15

Exit Audio Control mode (Volume control mode)

*Source tone memory: Puts the set up value in the memory per source.

⁄

•“USER”: The ranges selected lastly for Bass level, Middle level, and Treble level are recalled automatically.

1Select the source to adjust

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Audio Control mode Press the [AUD] knob.3Select the Audio item to adjust Press the [AUD] knob.4Adjust the Audio item Turn the [AUD] knob.5Exit Audio Control mode Press any button.

Press a button other than the [AUD] knob or [0] and [ATT] button.

Audio Setup

You can set Sound system , such as follows;

Adjustment Item	Display	Range
Front High Pass Filter	“HPF-F”	Through/40/ 60/80/100/120
		/150/180/220 Hz
Rear High Pass Filter	“HPF-R”	Through/40/ 60/80/100/120
		/150/180/220 Hz
Low Pass Filter	“LPF”	50/60/80/100/120/Through
		Hz
Subwoofer Phase	“SW PHASE”	Reverse (180°)/ Normal (0°)
Volume offset	“VOL-OFFSET”	–8 — ±0 (AUX: -8— +8)
Loudness	“LOUD”	OFF/ON
Dual Zone System	“2 ZONE”	OFF/ON

⁄

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by “Zone2” of <Function Control> (page 6).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [AUD] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 19) or [5]/[∞] button on the remote control

(page 28).

-The Audio Control has no effect on sub source.

1Select the source to adjust

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Audio Setup modePress the [AUD] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [AUD] knob.4Adjust the Audio setup item Turn the [AUD] knob.5Exit Audio Setup mode

Press the [AUD] knob for at least 1 second.

English 19