Kenwood KDC-MP642U, KDC-X693, KDC-X993 Item, Range, Display, Display, Display, X’Over setting, Setting speaker, Setting speaker, Setting overview, Turn the Control knob, 1Enter DTA setting mode

Sound Setup

DTA (Digital Time Alignment) setting

Adjusting fine tuning of the speaker position compensation value specified at <Cabin selection> (page 29).

1Enter DTA setting modeSelect “SOUND” > “Setup” > “DTA”.

For how to select Function Control item, refer to <Function Control> (page 6).

2Select the speaker you want to set

Setting speaker	Display
Front speaker	“Front”
Rear speaker	“Rear"
Subwoofer	“SW"

Turn the Control knob.

3Set the compensation value of the speaker position

Turn the Control knob and push the center when the desired value is displayed. Adjust between 0 and 14.44 feet.

Refer to “DTA” of <Menu Glossary> (page 48) on how to set the compensation value.

Exit DTA setting mode.

X’Over setting

Fine adjusting the following setting values corresponding to the X’Over values set in the section <Speaker Setting> (page 29);

Adjustment Item	Display		Range
Front High Pass Filter,	“FC”		Through, 30*, 40, 50*, 60, 70,
Rear High Pass Filter		80, 90*, 100, 120, 150, 180,
			220, 250* (Hz)
Front High Pass Slope,	“SLOPE”		-6, -12, -18, -24 dB/Oct
Rear High Pass Slope,
Subwoofer Slope *
Subwoofer Low Pass	“FC”	30*, 40, 50*, 60, 70, 80, 90*,
Filter		100, 120, 150, 180, 220,
			250*, Through (Hz)
Subwoofer Phase	“PHASE”		Reverse (180°)/ Normal (0°)

*Function of the KDC-X993/ KDC-X693.

1Enter X’Over setting modeSelect “SOUND” > “Setup” > “X’Over”.

For how to select Function Control item, refer to <Function Control> (page 6).

2Select the speaker you want to set

Setting speaker	Display
Front speaker	“Front”
Rear speaker	“Rear"
Subwoofer	“Subwoofer"

Turn the Control knob and push the center when the desired item is displayed.

3Select the item you want to set

Item		Setting overview
“Front”	>“FC”	Front High Pass Filter
	>“SLOPE”	Front High Pass Slope
“Rear"	>“FC”	Rear High Pass Filter
	>“SLOPE”	Rear High Pass Slope
“Subwoofer" >“FC”		Subwoofer Low Pass Filter
	>“SLOPE”	Subwoofer Slope
	>“PHASE”	Subwoofer Phase

Push the Control knob towards up or down.

4Set the X’Over value Turn the Control knob.5Repeat steps 2 to 4 to complete the X’Over setting.

6Exit X’Over setting mode Press the [FNC] button.

30 KDC-X993/ KDC-HD942U/ KDC-X693/ KDC-MP642U