“CD READ”Sets the method for reading CD.

 

1: Automatically distinguishes between audio file

 

disc and music CD when playing disc.

 

2: Forces playing as music CD.

“SWITCH PREOUT” Switches the preout between rear output (“REAR”) and subwoofer output (“SUB-W”)

REAR/SUB-W
“SP SELECT”

Fine-tuning so that the System Q value is optimal

 

when setting the speaker type as follows;

 

SP OFF: OFF

 

SP 5/4: For 5 & 4 in. speaker

 

SP 6*9/6: For 6 & 6x9 in. speaker

 

SP OEM: For the OEM speaker
“F/W UP”

Display the firmware version and update the

 

firmware.

 

MEDIA USB: Select a USB device.

 

MEDIA CD: Select CD.

 

For how to update the firmware, access our web

 

site.

 

http://www.kenwood.com/cs/ce/

(Factory setting: Underlined)

4Make a setting

Turn the [VOL] knob and press it when the desired item is displayed.

5Exit Function Setting mode

Press the [ ] button for at least 1 second.

Removing the Faceplate

The faceplate of the unit can be detached and taken with you, helping to deter theft.

Detach the faceplate
Press the Release button.
Reattaching the Faceplate
Refer to the following diagram when reattaching the faceplate.

¤

•After pressing the Release button, detach the faceplate immediately. If the faceplate is left attached, it can fall due to vibration and so on.

•The faceplate is a precision piece of equipment and can be damaged by shocks or jolts.

•Keep the faceplate in its faceplate case while detached.

•Do not place the faceplate (and the faceplate case) in areas exposed to direct sunlight, excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.

How to Reset Your Unit

If the unit fails to operate properly, press the Reset button. The unit returns to factory settings when the Reset button is pressed.

1Release the faceplate lock so that it can be removed.
Refer to <Removing the Faceplate> (page 19).
2Press the Reset button and reattaching the faceplate.
Reset button

English 19