The messages shown below display your systems condition.
TOC ERROR:• No disc has been loaded in the disc

 

magazine.

 

• The CD is quite dirty. The CD is upside-

 

down. The CD is scratched a lot.
ERROR 05:The disc is unreadable.
ERROR 77:

The unit is malfunctioning for some reason.

 

➪ Press the reset button on the unit. If the

 

“ERROR 77” code does not disappear,

 

consult your nearest service center.

IN (Blink):The CD player section is not operating

 

properly.

 

➪ Reinsert the CD. If the CD cannot be

 

ejected or the display continues to flash

 

even when the CD has been properly

 

reinserted, please switch off the power

 

and consult your nearest service center.

PROTECT (Blink):

The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated.

➪Wire or insulate the speaker cable properly and press the reset button. If the “PROTECT” code does not disappear, consult your nearest service center.

NA FILE:

An Audio file is played with a format that this

 

unit can’t support.
COPY PRO:A copy-protected file is played.

READ ERROR:

The file system of the connected USB device

 

is broken.

 

➪ Copy the files and folders for the USB

 

device again. If the error message is still

 

displayed, initialize the USB device or use

 

other USB devices.
NO DEVICE:The USB device is selected as a source

 

although no USB device is connected.

 

➪ Change the source to any source other

 

than USB. Connect an USB device, and

 

change the source to USB again.
N/A DEVICE:

• An unsupported USB device is connected.

 

• Connection to the iPod has failed.

 

➪ Check that the connected iPod is an iPod

 

that is supported. See <About Audio file>

 

(page 28) for information on supported

 

iPods.
NO MUSIC DATA/ERROR 15:•The connected USB device contains no playable audio file.•Media was played that does not have data recorded that the unit can play.
USB ERROR:Some trouble may have occurred to the

 

connected USB device.

 

➪ Remove the USB device, then cycle the

 

power switch to ON. If the same display is

 

repeated, use another USB device.
iPod ERROR:Connection to the iPod has failed.

 

➪ Remove the USB device and then

 

reconnect it.

 

➪ Confirm that the software for the iPod is

 

the latest version.
USB REMOVE (Blink):

The Remove mode has been selected for the USB device/iPod. You can remove the USB device/iPod safely.

NO NUMBER:

• The calling party does not notify a caller ID.

 

• There is no phone number data.
NO DATA:• There is no outgoing call list.

 

• There is no incoming call list.

 

• There is no missed call list.

 

• There is no phone book list.
NO ENTRY:The cell-phone has not been registered

 

(pairing).
HF DISCONCT: The unit cannot communicate with the cell- phone.HF ERROR 07: The memory cannot be accessed.

➪Turn off the power and on again. If this message still appears, press the reset button on the control unit.

HF ERROR 68: The unit cannot communicate with the cell- phone.

➪Turn off the power and on again. If this message still appears, press the reset button on the control unit.

UNKNOWN:

The Bluetooth device cannot be detected.

DEVICE FULL: 5 Bluetooth device have already been registered. No more Bluetooth device cannot be registered.

PIN CODE NG: The PIN code is wrong.CONNECT NG: The unit cannot be connected to the device.
PAIRING NG:

Pairing error.

English 35