Kenwood KRF-V4550D Listening to a source component, Adjusting the sound

Normal playback

18	Listening to a source component			Adjusting the sound
			VOLUME CONTROL
					MULTI CONTROL
		INPUT SELECTOR					SOURCE DIRECT
						SOUND

INPUT

SELECTOR

VOLUME

1Use the INPUT SELECTOR to select the source you want to listen to.

The input sources change as shown below:

Operations	Selecting a source using the INPUT SELECTOR knob
			1	"PHONO"
	2			"TUNER"
	3			"CD/DVD"
	4			"TAPE" or "MD"
	5			"VIDEO1"
	6			"VIDEO2"
		7		"DVD/6ch"

2Start playback from the selected source.

3Use the VOLUME CONTROL knob (VOLUME keys) to adjust the volume.

Selecting VIDEO 2/MONITOR

Depending on the component connected to the VIDEO 2/MONITOR jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as

appropriate. 7

PHONES MUTE VOLUME CONTROL

SPEAKER

SOUND

MULTI

CONTROL

BASS BOOST

MUTE

VOLUME

Adjusting the tone

You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode.

1Press the SOUND key to select the tone mode to be adjusted.

BASS: Select this to adjust the low frequency range. (Press the SOUND key once.)

TREB: Select this to adjust the high frequency range. (Press the SOUND key twice.)

SP		TI.VOL	L	C	R	FM	DIGITAL
		MUTE	LFE		SW	AM PRO LOGIC S.DIRECT
						MHz 3 STEREO MONITOR
RDS	EON	PTY	LS	S	RS	kHz DOWN MIX	DSP
TP	TA	NEWS

2Use the MULTI CONTROL to adjust the sound quality.

•The bass and treble levels are adjustable from -10 to +10 in 2 step increments.

•The adjustment item is displayed for approximately 8 seconds.

Once-touch low frequency emphasis (bass boost)

You can adjust the sound quality when the receiver is in the PCM stereo and analog stereo mode.

Press the BASS BOOST key.

•Press the key once to select the maximum (+10) low frequency emphasis setting.

•This key does not function when the receiver is in the sound quality or ambience effects adjustment mode.

Switching back to the previous setting

Press the BASS BOOST key again.