Kenwood KRF-V4550D Recording video, Recording audio (digital sources)

1Use the INPUT SELECTOR to select the video source (other than "VIDEO1") you want to record.

2Set the video deck connected to VIDEO 1 to record.

• Select the REC MODE to record a digital input source.

3Start playback, then start recording.

• With certain video software, recording may not be normal due to

the copy guard condition.

⁄

Switch on the REC mode to record a digital input source.

Usually use the A-REC(Auto-Record) mode to record audio input sources.

When the digital mode changes during recording in the A- REC mode, the audio may be interrupted momentarily.

Recording music in A-REC or M-REC mode

DIMMER

Recording

For A-REC mode:


	AUTO SOUND	DIIGIITAL
AM PRO LOGIIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX		DSP


	AUTO SOUND	DIGITAL		AUTO
	AUTO SOUND	DIGITAL
AM PROPRO LOGICLOGIC S.DIRECT				MEMO
MHz 3 STEREO		MONITOR		ST.
kHz DOWN MIX		DSP	TUNED

For M-REC mode:

4Play the source from the beginning and start recording.

•If the audio reproduction stops in the middle due to change in the input signals, etc., press the DIMMER key.

Operations

INPUT SELECTOR

1 Use the INPUT SELECTOR to select the source (CD, DVD or

VIDEO2) you want to record.

2Set the cassette deck to record.

3Press and hold the DIMMER key for more than 2 seconds to select the A-REC or M-REC mode.

• The mode changes every 2 seconds as shown below.

1 REC MODE off : The digital input record mode is switched off.

2A-REC MODE : The digital input signals (Dolby Digital, or PCM) are identified automatically and converted into stereo signals that are

ready for recording.

3 M-REC MODE : The input signal type at the moment this mode is selected is held throughout this mode.