•Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).

Status Message

You can send and receive 2-digit Status messages which may be decided in your talk group. Messages can contain up to 16 alphanumeric characters. Status messages range from 10 to 99 (80 ~ 99 are reserved for special messages).

A maximum of 15 received messages (combined status messages and short messages) can be stored in the stack memory of your transceiver.

■Transmitting

1 Select your desired zone and channel.

2 Press the key programmed as Status to enter Status mode (proceed to step 5) or Selcall + Status to enter Selcall mode (proceed to step 3).

3 Press / to select the station you want to call.

•If Manual Dialing is enabled, you can enter a station ID by using the DTMF keypad, or by using /. When using /, cycle through the digits to select a digit, then

press to set the digit and move the cursor to the right. Repeat this process until the entire ID is entered.

4Press to enter Status mode.

5Press / to select the status you want to transmit.

•If Manual Dialing is enabled, you can enter a status ID by using the DTMF keypad, or by using / (refer to step 3, above).

6Press the PTT switch or Side 2 key to initiate the call.

•“<COMPLETE>” appears on the display when the status has been successfully transmitted.

18