Connecting the System

Microcomputer malfunctions

If the system is connected correctly and still does not operate

normally or shows display errors, reset the microcomputer. (P.65)

 

1Connecting the AM loop antenna

The antenna supplied with the system is for indoor use. Place it as far as possible away from the main unit, your TV set, the speaker cords and the power cord and point it in the direction that gives the best reception.

z Connecting the antenna cord

1

2

3

 

Place the AM antenna cord as shown on the right and connect the lead (red) to the right side of the [AM] terminal and the lead (white) to the left side.

2Connecting the FM indoor antenna

The antenna supplied with the system is a basic antenna for indoor use. For stable signal reception, the use of an outdoor antenna (commercially available unit) is recommended. To connect an outdoor antenna, first remove the indoor antenna.

3Connecting the speakers

Notes on connecting the speaker cords

Never short-circuit the positive (+) and negative (–) ends of the speaker cords. (Do not touch the + and – cords together.) Mistakenly reversing the positive and negative polarity will result in unnatural sound and unclear sound source (e.g. musical instruments) locations.

z Preparing the ends of the speaker cords

Twist the plastic sleeve on the end of the cord as you pull it off.

zConnecting the speaker cords

1

2

3

4

Twist and remove

Loosen the knob

Insert the cord

Tighten the knob

English 11