OPERATING FEATURES
C 4. Transceiver Programming
Ir 4-1.lntroduction
The TK-9401941 transceiver IS programmed uslng an I B M PC or compatlbe machlne, a programming Inter- face (KPG4), and a programmlng dlsk (KPG-25D) Fig- ure 4 shows the setup for an IBM PC
..
Programming disk (KPG-25D)
Fig. 4
4-2. KPG-4 Description
(Optional PC programming interface cable)
The KPG-4 is reeded to connect the TK-9401941 to the computer. It has a circuit in the D-subconnector (25-pin) case that converts the RS-232C logic level to TTL level. The KPG-4 plug is connected to external socket of the TK-9401941 and t o the computer by a conversion cable (option) w i t h a 9-pin female connector and a 25-pin male connector.
4-3. Programming Software Description
KPG-25D is the programmlng software for the TK- 9401941, supplled on a 3 5" or 5.25" floppy disk Thls
software runs under MS-DOS (vers~on3.3 or later) on
'an IBM /XT, AT, or PS2, or on a compatible mach~ne Data car, de Input to or read from the TK-9401941, and
e d ~ t e don t h e screen Programmed data can be
4-4. Data Program Mode
In thts mode, data IS wr~ttenInto the flash memory In the transceiver, When the power IS turned on, data program mode can be entered ~mmedlately.When the KPG-4 IS connected and commands can be received, "PROGRAM" IS displayed to ~nd~catethat data program mode has been entered
Tunlng can be done uslng an IBM PC and KPG-25D, In the same way as In panel tun~ngmode You can carry out panel tunlng by select~ngtest mode on the KPG-25D menu screen and follow~ngthe ~nstructions on the screen See the KPG-25D Instruction manual for detalls