OPERATING FEATURES
4-5. Clone Mode (Figure 51
Programmed data is transferred f r o m one transceiver to another by using a microphone cable.
1 . Connect the master set to the slave set with.
2. Turn the slave set on
3 . Hold down the AUX key, turn the master set on, and keep the AUX key down for t w o more seconds. "CLONE" appears on the display t o indicate that clone mode has been entered.
4.Press the SCAN key on the master set.
The amark appears and data is sent from the master set to the slave set. "PROGRAM" appears on the slave set to show that it is receiving data.
5.When cloning is complete, the amark on the master set disappears and "CLOIVE" changes t o "END". The slave set is automatically reset and enters user mode.
If cloning fails, the master set shows "ERROR". Repeat steps 4 and 5.
If you wish to clone several sets, switch each of them on and reDeat 4 and 5.
5. Description of Each Modes
5-1. Dealer mode
To enter this mode, hold down the GROUP UP key, turn the transceiver on, and keep the GROUP UP key down for t w o more seconds The mode can be inhibited by programming.
SYSTEM key
Used to select one of programmed frequencies 1 to 1 6 . If no frequency data has been preset, the frequency listed in Table 1 is written as the default value.