Replacing Fuses
If the fuse blows, determine the cause, then correct the problem. After the problem is resolved, replace the fuse. If newly installed fuses continue to blow, disconnect the power cable and contact your authorized Kenwood dealer or an authorized Kenwood service center for assistance.
|
|
| Fuse Location | Fuse Current Rating | |
|
|
|
|
| |
Transceiver | 15 A | ||||
(located on the DC connector) | |||||
| |||||
|
|
|
|
| |
Supplied DC power cable | 20 A | ||||
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
| |
Only use fuses of the specified type and rating; otherwise the transceiver could be damaged.
Fuse holder (E type)Fuse holder (K, M4 types)
Fuse | Fuse holder | Fuse |
| ||
|
| |
Fuse holder |
|
|
Operation Panel and Microphone Connection
Plug the microphone plug to the MIC jack, then connect the Operation panel to the TX/ RX unit with the supplied cable.
•Attach the microphone hanger to an appropriate position using the screws included in the screw set.
Microphone | TX/ RX unit |
MIC jack
Line filter
Installing the Line Filter Install the line filter approximately 3 cm from the connector.
Panel jack
Modular plug cable | Operation panel |
Line filter