Set an appropriate angle for the TX/ RX unit, using the 3 screw slots on the rear edge of each bracket side.
•
Ensure that all hardware is tightened, to prevent vehicle vibration from loosening the bracket or TX/ RX unit.
SEMS screw (M4 x 10 mm)
•
Flat washer
2 Position the transceiver, then insert and tighten the supplied hexagon SEMS screws and flat washers (4 of each are supplied, 2 for each side of the bracket).
The bracket must be installed so that the 3 screw slots on the edge of each bracket
side are facing the back.
Self-tapping screw
(5 x 16 mm)
•
Mobile Installation
n TX/ RX Unit Installation
Select a safe, convenient location inside your vehicle that will minimize danger to your passengers and yourself while the vehicle is in motion. Consider installing the transceiver under the dash in front of the passenger seat so that knees or legs will not strike the radio during sudden braking of your vehicle. Try to a pick well-ventilated location that is shielded from direct sunlight.
Note: You may experience interference on your GPS receiver when using in or around 438.8 MHz (A band) and/or 443.8 MHz (B band). To eliminate the interference, ensure that the transceiver is installed at a location separate from your GPS receiver.
1 Install the mounting bracket in the vehicle using the supplied self-tapping screws and flat washers (4 of each are supplied).
• The bracket can be mounted with the bracket opening facing down, for under dash mounting, or facing up.