| n Operation Panel Installation | Tapping screw |
1 Clean and dry the installation location. | (4 mm x 12 mm) |
| Flat washer |
Do not install the bracket close to an air bag.
2 Remove the release paper from the base |
of the panel bracket, then secure it in |
Panel bracket
place using the 3 supplied |
screws. |
• Allow the panel to set for a while, to |
ensure it remains fast. Otherwise, |
vibrations may occur. |
• After removing the release paper, it cannot |
be reused. |
3 Attach the panel holder to the panel |
bracket using the 2 supplied SEMS |
screws. |
4 Attach the operation panel to the panel |
holder so that it locks in place. |
Adhesive tape
Panel holder 
SEMS screw (M4 x 10 mm)
Be sure to use a 12 V vehicle battery that has sufficient current capacity. If the current to the transceiver is insufficient, the display may darken during transmission or the transmit output power may drop excessively. Never connect the transceiver to a 24 V battery.
Engine compartment | Passenger compartment |
Fuse holder (E type)
Black
Fuse holder |
|
| |
(K, M4 types) | Red (+) |
| |
| cable |
| |
| Rubber grommet | Fuse holder | |
| (K, M4 types) | ||
12 V vehicle | |||
Fuse holder | |||
battery |
| ||
|
| (E type) | |
DC power cable