Installing the VGS-1 Unit

Follow the instructions below to install the VGS-1 unit.

Note: The VGS-1 is sold depending upon area.

1Remove the 8 screws from the cover of the base unit, then remove the cover itself from the unit.

2From the 5 black cushions supplied with the VGS-1, select the thickest rectangular cushion (20 x 30 x 12 mm) and attach it to the top surface of the VGS-1 unit.

•To prevent interference to the terminal of the VGS-1, ensure that you attach the thick square cushion to the base plate surface.

3From the remaining cushions, select the thickest square cushion (21 x 21 x 2.5 mm) and attach it to the printed circuit board.

•The remaining cushions are not used with this transceiver.

•Ensure that the cushion is placed within the guidelines on the PCB.

cushion

VGS-1

cushion

guidelines

connector

4Insert the VGS-1 unit into the connector on the transceiver.

• Press down on the top of the VGS-1 unit to ensure that it is securely attached to the connector.

5 Replace the cover on the base unit and secure it using the 8 screws.

39