&20081,&$7,1*$,'6

&:%5($.,1

Break-in allows you to transmit CW without manually switching between transmission and reception modes. Two types of Break-ins are available: Semi Break-in and Full Break-in.

Semi Break-in:

When the key contacts open, the transceiver automatically waits for the duration of the time period you selected. The transceiver then returns to reception mode.

Full Break-in:

As soon as the key contacts open, the transceiver returns to reception mode.

86,1*6(0,%5($.,125)8//%5($.,1

1Press [CW/FSK (REV)] until you select CW mode.

• “CW” appears.

2Press [VOX (LEV)].

• “” appears.

3Press and hold [KEY (DELAY)].

•The current setting (FBK or delay time) appears. The default is 50 (500 ms).

4Turn the MULTI/CH control to select “FBK” (Full Break-in) or a delay time for Semi Break-in.

•Delay time ranges from 5 to 100 (50 ms to 1000 ms) in steps of 5.

5Begin sending.

•The transceiver automatically switches to transmission mode.

•When FBK (Full Break-in) is selected: The transceiver immediately switches to reception mode when the key opens.

•When a delay time is selected:

The transceiver switches to reception mode after the delay time that you have selected has passed.

6Press [CLR] to exit.

Note: FBK (Full Break-in) cannot be used with the TL-922/ 922A linear amplifier.

(/(&7521,&.(<(5

This transceiver has a built-in electronic keyer that can be used by connecting a keyer paddle to the transceiver’s rear panel. Refer to “Keys for CW (PADDLE and KEY)” {page 2} for details regarding this connection. The built-in keyer supports lambic (squeeze) operation.

(/(&7521,&.(<(502'(

There are 2 modes of operation when using an electronic keyer for lambic keying operation. Mode A completes the current key sequence you are sending when you release the paddles. Mode B sends one more key, opposite the current key you are sending, upon releasing the paddles.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to select Menu No. 32.

2Press [M.IN]/ [SCAN (SG.SEL)] to select “A” or “B” (default).

3Press [MENU] to exit Menu mode.

&+$1*,1*.(<,1*63(('

The keying speed of the electronic keyer is fully adjustable. Selecting the appropriate speed is important in order to send error-free CW that other operators can copy solidly. Selecting a speed that is beyond your keying ability will only result in mistakes. You will obtain the best results by selecting a speed that is close to the speed used by the other station.

1Press [CW/FSK (REV)] until you select CW mode.

• “CW” appears.

2Press [KEY (DELAY)].

•The current keying speed appears. The default is 20 (wpm).

3While keying the paddle and listening to the TX (transmission) sidetone, turn the MULTI/CH control to select the appropriate speed.

•The speeds range from 4 to 60 wpm, in steps of 1 wpm. The larger the number, the faster the speed.

4Press [KEY (DELAY)] again to complete the setting.

Note: When using the semi-automatic “Bug” function, the selected speed applies only to the rate that dots are sent.

Q ,QYDOLG%UHDN,Q2SHUDWLRQ

You can make break-in operation invalid while performing the keying speed adjustment.

To switch this function ON, access Menu No. 43, and select “on” (default is “oFF”).

•“VOX” blinks when break-in operation is enabled.

33