&20081,&$7,1*$,'6

$872&:7;,166%02'(

If you operate both SSB and CW modes, you can configure the transceiver to change the operating mode from SSB (USB or LSB) to CW and then transmit in CW mode automatically when you operate the CW keyers.

The mode automatically changes from USB to CW and LSB to CWR, regardless of the setting for Menu No. 42 (Frequency correction for changing SSB to CW). Therefore, when the CW signal is received in SSB mode, you can operate the paddle or keyer to immediately communicate CW with another station.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to access Menu No. 41.

2Press [M.IN] to select “on”.

3Press [MENU] to exit Menu mode.

Note: You must switch the CW Break-in function ON to change the mode and transmit in CW mode {page 32}.

0,&83':1.(<3$''/(02'(

This function allows you to send CW messages without using an optional paddle {page 2}. The Mic [UP] key can be used as the dot paddle and the Mic [DWN] key can be used as the dash paddle.

To activate Mic UP/ DWN key Paddle mode:

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to access Menu No. 40.

2Press [M.IN] to select “PA”.

3Press [MENU] to exit Menu mode.

•Press and hold Mic [DWN] to send dots or Mic [UP] to send dashes in CW mode.

4To exit Mic UP/ DWN key Paddle mode, access Menu No. 40 and select “PF”.

6:$3'27$1''$6+3$''/(326,7,216

This function reverses the position of the dot and dash paddle positions. As a default, the left paddle sends dots and the right paddle sends dashes. When this function is ON, the left paddle will send dashes and the right paddle will send dots.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to access Menu No. 39.

2Press [M.IN] to select “on”.

3Press [MENU] to exit Menu mode.

•The left paddle now sends dashes and the right paddle now sends dots. To return to the normal paddle positions, access Menu No. 39 and select “oFF”.

36