Kenwood TS-590S MIC, ——A ——, [PF A], [SEND], ——B ——, ——C ——, [PF B], [GENE], [7 (3)], [10 (4)], [14 (5)], [18 (6)], [1.8 (1)], [3.5 (2)], [VOX (LEV)], [AT (TUNE)]

*(77,1*$&48$,17('

)52173$1(/

A C D E F G

B H

—— A ——

[]

Press and hold to switch the transceiver power ON and OFF {page 10}.

[PF A]

You can assign a function to this Programmable Function key {page 54}.

[ATT (RX ANT)]

Press to turn the receiver attenuator ON or OFF {page 40}. Press and hold to enable or disable the RX-ANT terminal {page 50}.

[PRE (ANT 1/2)]

Press to turn the pre-amplifier ON or OFF {page 40}. Press and hold to select either ANT 1 or ANT 2 {page 50}.

[VOX (LEV)]

In voice mode, press to turn the VOX (Voice-Operated Transmit) function ON or OFF {page 30}. In CW mode, press to turn the Break-in function ON or OFF {page 32}. Press and hold to adjust the microphone input gain for VOX operation.

[PROC (LEV)]

Press to turn the Speech Processor ON or OFF {page 31}. Press and hold to adjust the Speech Processor input level.

[SEND]

Press to turn transmission ON or OFF.

[AT (TUNE)]

Press to turn the internal antenna tuner ON or OFF {page 50}. Press and hold to start tuning the automatic antenna tuner.

—— B ——PHONES jack

Mate with a 6.3 mm (1/4") diameter, 2-conductor (mono) or 3-conductor (stereo) plug for connecting a set of headphones {page 2}.

MIC connector

Connect a microphone to this connector {page 2}.

—— C —— [METER (DRV)]

Press to switch the meter type. Press and hold to turn the Drive Out function ON or OFF {page 50}.

[PF B]

You can assign a function to this Programmable Function key {page 54}.

[MIC (CAR)]

Press to adjust the microphone gain {page 13}. While the Speech Processor function is ON, press to adjust the Speech Processor output level {page 31}. Press and hold to adjust the carrier level {page 23}.

[PWR (TX MONI)]

Press to adjust the transmission output power {pages 13, 55}. Press and hold to turn the transmission signal monitor function ON or OFF {page 56}.

[KEY (DELAY)]

Press to adjust the internal electronic keyer speed {page 33}. Press and hold to adjust the VOX delay time for voice mode {page 30} or Break-in time (Full Break-in/ Semi Break-in time) for CW mode.

[GENE]

Press to select the general coverage band memory {page 11}.

[1.8 (1)]

Press to select the 1.8 MHz band memory {page 11} or enter keypad number 1.

[3.5 (2)]

Press to select the 3.5 MHz band memory {page 11} or enter keypad number 2.

[7 (3)]

Press to select the 7 MHz band memory {page 11} or enter keypad number 3.

[10 (4)]

Press to select the 10 MHz band memory {page 11} or enter keypad number 4.

[14 (5)]

Press to select the 14 MHz band memory {page 11} or enter keypad number 5.

[18 (6)]

Press to select the 18 MHz band memory {page 11} or enter keypad number 6.

4