6&$1

6&$1+2/'

This function stops Program Scan for approximately

5 seconds, then resumes Scan when you jump to the desired frequency by turning the Tuning control or the MULTI/CH control, or by pressing Mic [UP]/ [DWN].

To use this function, access Menu No. 21, and select “on”. The default is OFF.

0(025<6&$1

Memory Scan monitors all memory channels in which you have stored frequencies (All-channel Scan) or only a desired group of memory channels (Group Scan).

Scan automatically stops at a channel where a signal is present, regardless of the operating mode. The transceiver will either remain on that channel for a short time (Time-Operated mode) or until the signal drops out (Carrier-Operated mode). Use Menu No. 22 to select the mode. The default is “to” (Time- Operated).

6&$15(680(

The transceiver stops scanning at the frequency (or memory channel) where a signal is detected. It then continues scanning according to which resume mode you have selected. You can choose one of the following modes. The default is Time-Operated mode.

•Time-Operated mode (“to”)

The transceiver remains on a busy frequency (or memory channel) for approximately 6 seconds, then continues to scan, even if the signal is still present.

•Carrier-Operated mode (“co”)

The transceiver remains on the busy frequency (or memory channel) until the signal drops out. There is a 2 second delay between signal dropout and scan resumption.

1Press [MENU], then press [Q-M.IN]/ [Q-MR]or turn the MULTI/CH control to select Menu No. 22.

2Press [M.IN]/ [SCAN (SG.SEL)] to select “to” (Time-Operated) or “co” (Carrier-Operated).

3Press [MENU] to exit Menu mode.

You can lock out the memory channels that you prefer not to monitor while scanning (refer to “Memory Channel Lockout”).

$//&+$11(/6&$1

Use the following procedure to scan all the memory channels that contain frequency data in sequence, ignoring the Memory Group number.

1Select Time-Operated or Carrier-Operated mode via Menu No. 22.

2Press [M/V] to enter Memory Recall mode.

3Turn the SQL control to adjust the squelch threshold to mute the speaker.

4Press and hold [SCAN (SG.SEL)] to enter Scan Group Select mode.

•Turn the MULTI/CH control to select the Memory channel group.

•MGROUP–0 represents Memory channels 0 ~ 9, MGROUP–1 represents Memory channels 10 ~ 19 and so on up to MGROUP–9 which represents Memory channels 90 ~ 99 and MGROUP-P which represents Memory channels P0 ~ P9.

5As you select the Memory Groups using the MULTI/CH control, press [SCAN (SG.SEL)] to select “oFF” for all Memory Groups.

6Press [SCAN (SG.SEL)] to return to Memory Recall mode.

7Press [SCAN (SG.SEL)] to start All-channel Scan.

•Scan starts from the current memory channel and ascends up through the channel numbers. (The scan direction cannot be changed.)

•To jump to a desired channel while scanning, turn the MULTI/CH control, or press Mic [UP]/ [DWN].

8To stop Scan, press [SCAN (SG.SEL)] or [CLR].

Note:

XIf you have turned the SQL control clockwise, far beyond the squelch threshold, Scan may fail to stop at a channel where a signal is present. If this happens, turn the SQL control slightly counterclockwise.

XStarting Memory Scan switches OFF the RIT and XIT functions.

48