Kenwood TS-990S Important

1. Relevant Models

This operations guide is for the TS-990S.

Using the TS-990S and the KENWOOD NETWORK COMMAND SYSTEM (hereinafter

called "KNS") enables transceiver operations by remote control using a home LAN or the

internet.

KNS is a system configured using PCs, network environments, ARCP-990 (a Radio

Control Program; hereinafter called "ARCP-990”), ARHP-990 (a Radio Host Program;

hereinafter called “ARHP-990”), and ARVP-10 (a VoIP Program; hereinafter called “VoIP

Program”) for remote control of the TS-990S.

Note: If the firmware version of the TS-990S is V1.00, please update it to V1.01 or later.

Important

 To configure the system, knowledge not only of transceivers but also of PCs and

networks is required. JVC KENWOOD does not offer support for customer PCs

and Networks. Furthermore, for operations relating to actual transmitting, note that

procedures according to the Radio Act are also required.

 Operations via networks may be delayed due to unavoidable principles.

Consequently, do not perform operations (such as contests or pile-ups requiring

quick responses) for which delays are likely to be a problem.

 Even if you set by the procedures described in this document, the feature may

not work properly because of the combination of PC, the network environment

and the sound device.

 Refer to “5. Limitations Caution!” for other limitations.

 JVC KENWOOD Corporation shall bear no responsibility for related damage such

as damage caused by missed communications and dialog opportunities due to

incorrect customer settings, nonconformances, or misoperations as a result of

using this document or the ARCP-990, ARHP-990 or ARVP-10 software.