29
Question
Answer
Operations
If there is a connection request from
the remote station while the host
station is not being used, a
message is displayed and
connections to the host station are
disabled.
Is the Windows energy save mode
operating, and has the power supply to
the host station HDD been disabled?
When the HDD power supply is turned
OFF, the HDD power supply is turned
ON to respond, but at this time nothing
can be returned until the response to
the remote station has timed out.
Consequently, set the Windows power
supply function settings so that the HDD
power supply does not turn OFF.
An audio I/O between the host
station PC and transceiver cannot
be performed correctly.
Check that a default device is specified
as the device connected to the TS-990S
using the Windows sound settings on
the host station PC.
There is no modulation even when
the ARCP-990 “Send” button is
pressed.
Refer to "Transmitting using the
ARCP-990" in "4.4. Setting
Transmission Methods for Audio Input
to the ACC2 Connector" of this
document, and check the setting.
Audio input level to the TS-990S may be
too low. Refer to "Audio I/O level
settings" in "4.3. Transceiver Settings"
of this document, and adjust the audio
input level.
On the ARHP-990, check that the
setting of the VoIP input device is not
wrong.