13 MEMORY FEATURES

■ Memory Scroll

MEMORY-VFO SPLIT OPERATION

1Press [M.IN] to enter Memory Scroll mode.

•The memory channel that was last selected appears.

Under “ENHANCED COMMUNICATIONS” {page 31}, you learned about split-frequency operation using two VFOs. Recalling a split-frequency channel is another way to perform split-frequency operation. If you access Menu No. 06A and select ON, you can also use a memory channel and a VFO together for this operation, as follows:

•RX: Memory channel

TX: VFO A or VFO B

2Turn the MULTI/ CH control, or press Mic [UP]/ [DWN] to step through the memory channels.

•You can also change channels by entering a 3-digit number, such as 012, using the numeric keys, then pressing [ENT].

3To exit Memory Scroll mode, press [CLR].

•The transceiver re-displays the memory channel or VFO frequency that was selected before you activated Memory Scroll.

Note: Do not press [M.IN] again after entering Memory Scroll mode. Pressing [M.IN] results in over-writing the current VFO data to the memory channel you selected.

■Temporary Frequency Changes

After retrieving frequencies and associated data in Memory Recall mode, you can temporarily change the data without overwriting the contents of the memory channel.

1Access Menu No. 06B and select ON.

•Skip this step when changing only the associated data (not the frequency).

2Recall a memory channel.

3Change the frequencies and associated data.

•Use only the Tuning control to select a frequency.

4If necessary for future use, store the changed data in another memory channel. Refer to “Channel ➡ Channel Transfer” {page 61}.

Note: Memory channel data can also be changed while using the TF-SET function.

•RX: VFO A or VFO B

TX: Memory channel

To use a memory channel for receiving:

1Access Menu No. 06A and select ON.

2Press [A/B] to select the VFO that you will use for transmitting.

•“tA” or “tB” appears to show which VFO is selected.

3Select the frequency for transmitting.

4Recall a memory channel by pressing [VFO/M].

5Turn the MULTI/ CH control to select a memory channel to receive.

6Press [SPLIT].

7The VFO A frequency appears on the sub-display. If you want to use the VFO B frequency to transmit, press [SPLIT] again.

8Press [SEND] or Mic [PTT] to transmit on the frequency shown on the sub display.

9Press [SPLIT] to exit the SPLIT operation.

•If Split operation is still selected using VFO A or VFO B, press [SPLIT] again to exit Split operation.

To use a memory channel for transmitting:

1Access Menu No. 06A and select ON.

2Recall a memory channel by pressing [VFO/M].

3Turn the MULTI/ CH control to select a memory channel to transmit.

4Press [VFO/M] to return to VFO mode.

5Press [SPLIT]. The other VFO frequency appears on the sub display for transmission (Normal SPLIT operation).

6Press [SPLIT] again. The memory channel you selected in step 3 appears on the sub-display for transmission.

7Press [SEND] or Mic [PTT] to transmit on the frequency in the memory channel.

8Press [SPLIT] to exit SPLIT operation.

60