In case of difficulty
Tuner
Symptom | Cause | Remedy |
|
|
|
|
|
| Radio stations cannot be received. | • No antenna is connected. | • Connect an antenna. | ( |
| • The broadcast band is not set properly. | • Set the broadcast band properly. |
|
| • The frequency of the desired station is not | • Tune the frequency of the desired station. | |
| tuned. |
| ⁄ |
|
|
| |
| Interference. | • Noise due to ignition noise from an automobile. | • Install the outdoor antenna away from the | |
|
| road. |
|
| • Noise due to interference from an electric | • Turn off the power to the appliance. |
|
| appliance. | • Install the receiver farther away from the TV. | |
| • Noise due to a nearby TV set. | ||
|
|
| |
| A station which was preset cannot be | • The preset station belongs to a frequency that | • Preset a station with a receivable frequency. | |
| received by pressing the corresponding | cannot be received. | • Preset the station again. |
|
| numeric key. | • The preset memory was cleared because the |
| |
| power cord had been unplugged for a long |
|
|
| period of time. |
|
|
|
|
|
|
Remote control unit
Symptom | Cause | Remedy |
|
|
|
| |
| Certain inputs cannot be selected using the | • No setup codes registered for the respective | • Register a setup code at the respective input(s). | |
| remote control. | input(s). |
| w |
|
|
| |
| Remote control operation is not possible. | • The remote control unit is set to a different | • Press the RCV MODE key to select the | |
| operation mode. | appropriate operation mode. |
|
| • Batteries are exhausted. | • Replace with new batteries. |
|
| • The remote control unit is too far away from | • Operate the remote control unit within the | |
| the main system, controlling angle is too large, | controllable range. |
|
| or there is an obstacle between the receiver |
|
|
| and the remote. | • Place the disc or tape in the source component | |
| • No disc or tape is placed in the source | ||
| component. | which you want to play. |
|
| • An attempt is made to play a tape which is | • Wait until recording has completed. | |
| being recorded in the cassette deck. | • Press any of the Source keys or |
|
| • The remote control has not been set to the | SOURCE | |
| operation mode for the component you wish | key to activate the operation mode for the | |
| to control. | component you want to control before | |
|
| operation. | w |
|
|
|
|