Basic remote control operations for other components
Storing the remote control code of the other components
The remote control unit can store the remote control code of the other components and you can operate the other components from the remote control unit. The remote control code is stored on the key or memory of the remote control unit.
Storing on the key
You can store the remote control code to the key as shown below:
2Press and hold the LEARN key for 3 seconds until 
blinks twice, then release the LEARN key.
3Press the Numeric key to enter 9, 7, 5.
4Press any of the Source keys (DVD/6CH, VIDEO 1, VIDEO 2, VIDEO 3, CD/DVD, PHONO, AV AUX, MD/TAPE, TV MODE) to select the input of the desired remote control unit.
• While in Tuner mode, learning code function is not available.
5Press the desired key of the remote control unit.
• “LEARN” and 
appear on the display.
6From the remote control unit of the other source, press the key that you want to store.
• The remote control code is sent to the remote control unit.
• “OK” appears when finished.
• If the code cannot be stored after a few attempts, “ERROR” will appear. Repeat from step 2 onwards.
7The remote control code is stored on the key of this remote control unit.
8Repeat step 4 to 6 to store additional components until all the desired components are stored.
9To exit the learning mode, press and hold the LEARN key for 3 seconds until 
blinks twice.
0To clear the stored remote control code of the other sources:
1 Press and hold the LEARN key for 3 seconds until 
blinks twice, then release the LEARN key.
2 Press the Numeric key to enter 9, 7, 6.
3 Press the Source key, then press the stored key twice until 
blinks twice.
• 
blinks twice to indicate that the stored remote control code are deleted.
1Point the infrared ray system part of another remote control unit to the remote sensor of the remote control unit.
Receiving part
Remote control 
unit of the other
3 to 4 cm source.
(0.1 to 0.13 feet)