Keys Fitness T240, T260 owner manual Nvram Test, Eprom test, Keypad Test, Display Test

When you access the Diagnostics menu, you will notice the following message: “TXXX VERSION”

The message above indicates the version of the computer software installed in your computer display monitor. This information is helpful in diagnosing certain computer related conditions. Keep in mind that the version number may change depending on the model number of your T240 – T260 treadmill.

The T240 – T260 treadmill allows you to perform the following tests :

•	NVRAM TEST	•	ELEVATION CALIBRATION
•	EPROM TEST	•	STATISTICS
•	KEYPAD TEST	•	SAFETY KEY TEST
•	DISPLAY TEST	•	ERROR LOG
•	BEEPER TEST	•	SPEED SENSOR TEST
•	HEART RATE TEST	•	CURRENT TEST
•	BELT ALIGNMENT	•	MAINTENANCE
•	MOTOR CHECK

To perform any one of the above procedures, press the Speed INCREASE or DECREASE keys to select the one you want and press the JustGo®/ENTER key to accept.

NVRAM Test

The NVRAM (Non-Volatile Random Access Memory) test will not erase all stored information such as user identification, and all saved programs. The NVRAM is a computer chip that saves information even when the treadmill has been turned off.

1.In the Diagnostics menu, select the “NVRAM TEST” and accept it by pressing the JustGo®/ ENTER key.

2.Press the JustGo™/ENTER key to start the NVRAM test. The NVRAM test will perform automatically.

EPROM test

The EPROM test allows you to determine if the program stored in the EPROM chip is intact.

1.In the Diagnostics menu, select the ‘‘EPROM TEST’’ and accept it by pressing the JustGo®/ ENTER key. The EPROM TEST will perform automatically.

•The display will show ‘‘EPROM IS OK’’ if the EPROM is intact and will display the result.

•The display will show ‘‘EPROM IS NOT OK’’. This means the EPROM might be damaged.

2.Press the CLEAR/STOP key to terminate the test.

Keypad Test

The keypad test allows you to verify that each key is responding when pressed.

1.Press each key one at a time and verify the confirmed response on the screen. Example, pressing the Elevation INCREASE key will cause the screen to display “ELEVATION INCREASE” indicating that the key press was recognized.

2.Press the CLEAR/STOP and JustGo®/ENTER keys simultaneously to terminate the keypad test.

Display Test

The display test allows you to verify that each display light is properly working. If you notice that one or more areas on the screen do not light up during an exercise, you should perform this test.

1.In the Diagnostics menu, select the “DISPLAY TEST” and accept it by pressing the JustGo®/ ENTER key.

2.Now the display will illuminate a certain way. To proceed to the next display patterns, press any key. Press Stop to terminate.

23