Keyspan: Remote for iTunes - User Manual (Mac OS X & Windows)
6 Troubleshooting
Before You Begin
The Keyspan remote and receiver operate differently when directly connected to an Airport Express as opposed to when they are connected directly to your computer. Because of this, the process of troubleshooting problems is also different.
If your Keyspan remote and receiver hardware are connected to an Airport Express, please skip ahead to the Airport Express Troubleshooting subsection later in this manual.
If your Keyspan remote and receiver hardware are connected to directly to your computer, please
read the Troubleshooting (Keyspan Hardware Connected To Your PC) subsection...
IMPORTANT NOTE: Please follow these instructions in order as each sub section builds on the previous one. If you cannot proceed past a certain sub section, please contact Keyspan technical support.
Troubleshooting (Keyspan Hardware Connected To Your PC)
Before you begin, please make sure that you already have:
installed the latest version of the Keyspan software
connected your Remote for iTunes RECEIVER to your computer (do not connect the RECEIVER to your Airport Express for troubleshooting )
turned on your computer
If you have not done any of the above, please do so now and return to this section when you have finished.
Tech Note: You can find the latest version of the Keyspan Remote Software at:
http://www.keyspan.com/
Troubleshooting: Receiver Status Lights
Disconnect and then reconnect the Keyspan Remote for iTunes Receiver from your computer's USB port. You should notice the Remote for iTunes Receiver's red light turn on and then turn off. This indicates that the Keyspan Remote for iTunes Receiver driver software was properly loaded.
This User Manual applies to the Keyspan Remote for iTunes Software Version 2.3
Rev 2005jun01 | Page 20 |
