Operating and Installation Instructions
Install at least one (1) foot away from fluorescent lights, electronic noise may cause nuisance alarms. Do not place in direct sunlight and keep out of insect infested areas. Extreme temperatures will effect the sensitivity of the Smoke/CO Alarm. Do not install in areas where the temperature is colder than 40 degrees Fahrenheit (4.4 Celsius) or hotter than 100 degrees Fahrenheit (37.8 Celsius), such as garages and unfinished attics. Do not install in areas where the relative humidity (RH) is above 85%. Place away from doors and windows that open to the outside.
Smoke alarms are not to be used with detector guards unless the combination (alarm and guard) has been evaluated and found suitable for that purpose.
C. How to Install:To help identify the date to replace the unit, a label has been affixed to the side of the alarm. Write the “Replace by” date (7 years from initial power up) in permanent marker on the label. See Alarm Replacement section for additional information.
Remove mounting |
|
plate from the back |
|
of the unit by hold- |
|
ing the rim of the |
|
mounting plate and |
|
twisting counter- |
|
clockwise (left). See |
|
Diagram C. Hold the |
|
mounting plate |
|
against the selected |
|
installation location |
|
(wall or ceiling) and | Remove |
mark the center of |
|
the holes with a | DIAGRAM C |
pencil. |
|
Mounting Plate
Install
13