6.Remove the protective skin from the screw covers. Snap the screw covers into the handle trim section.

7.If the door gap is uneven, see “Adjust and Remove Door.”

Top Grille Panel

1.Grasp both ends of the top grille.

2.Push straight up; then pull straight out. Place the top grille panel-side down on a soft working surface.

BAB

A. Top grille

B. Cabinet side trim

3.Remove one end cap by loosening the nuts and sliding the end cap off.

A

 

C

 

B

 

D

 

A. Bottom rail

C. End cap

B. Nuts

D. Top rail

4.Slide the panel into the top grille channel and reattach the end cap.

A

A. Panel

5.Replace the top grille in the cabinet side trims and pull the panel down slightly to lock it into place.

BAB

A. Top grille

B. Cabinet side trim

Install OverlaySeries Custom Panels

IMPORTANT:

Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call 1-800-422-1230.

In Canada, visit www.KitchenAid.ca, or call 1-800-461-5681.

Create custom door overlay panels according to the specifications in the “Overlay Series Custom Panels” section.

KitchenAid is not responsible for the removal or addition of molding or decorative panels that would prevent the refrigerator from being serviced.

Door Panel Installation

1.Remove all tape and door bracing from the refrigerator door and freezer drawer.

2.Open the refrigerator door and freezer drawer and remove the trims.

A

B

A. Refrigerator door trims

B. Freezer drawer trim

20

Page 20
Image 20
KitchenAid 2307890A manual Install OverlaySeries Custom Panels, Door Panel Installation