KitchenAid 3182048 installation instructions Now start . n n n, Itt

Now start . n n n

El1 Place cardboard or other form of

. protection on top of a flat surface where you can easily assemble the downdraft

vent system. Remove downdraft blower box and motor section from cartons. Remove any shipping materials, tape and protective film from downdraft blower box and motor. Remove parts package from inside blower box opening. Remove capacitor from motor.

Determine which direction (right or left)

2 the blower box with motor attached will

cl g need to be installed.

(two	on each side)			\’	1 if-f
that	attach		the
wiring		box	to the blower box. Place		screws and
wiring		box	in a safe place.

cover to blower box	‘V
so that the control end

will be at the front of the cutout.

Use a Phillips screwdriver to

5 n remove the

El screws that attach the legs to the blower box. Place the slotted area of legs over

the area where the screw openings are located. Replace the screws but Do Not tighten screws.

Excessive Weight Hazard

Use two or more people to move and install downdraft vent.

Failure to follow this instruction can result in back or other injury.

Determine which direction (right, left or 08n down) the ductwork will run from the

blower duct when installed in the cabinet. Place the motor on the blower box so that the duct opening is in the position you need to complete the ductwork. Do Not tighten screws.

Measure location of blower motor duct.

6” blower	motor	I
exhaust	duct \	I4	*

1 -

ITT -

/ I

leg-mounting hole

Transfer measurements and cut duct opening in cabinet floor or wall dependmg on your installation.

Cut opening / \

191. Determine center of blower motor duct in relation to one leg-mounting hole. Use

this measurement to locate center of blower motor duct cutout. Cut 6-inch duct opening.

13