Tools/Parts Electric Cooktop and Grill
Tools and
materials needed
for installation:
Electric cooktops and grills
pipejoint compound
Downdraft vents
l
Phillips screwdriver
l
metal snips
l
wire stripper or utility knife
l
duct tape
l
caulking gun
l
measurmg tape/ruler
l
flat-blade screwdriver
or 7/16” nut driver
l
pencil
l
power supply cable
l
saber saw or key
hole saw
l
drill
l
118” drill bit
l
pliers
l
level
l
1Omm or 3/8”
nut driver or ratchet
Parts supplied for
installation:
Downdraft vents
1 control knob
1 capacitor bracket
4 wire nuts
2 conduit connectors
2 #8 Phillips-head
screws to attach
literature capacitor bracket
4 #6 Phillips-head
screws to attach
plenum
Electrical
requirements
IB.(
COOKTOPS AND GRILLS MUST
BE CONNECTED WITH COPPER
WIRE ONLY.
,Hl
Failure to do so can result in death, fire,
If codes permit and a separate ground wire is
used, it is recommended that a qualified
electrician determine that the ground path is
adequate.
Do Not ground to a gas pipe.
Check with a qualified electrician if you are
not sure the appliance is properly grounded.
Do Not have a fuse in the neutral or ground
circuit.
IMPORTANT: Save Installation Instructions
for electrical inspector’s use.
A. A three-wire, single phase 240-volt,
60-Hz, AC-only electrical supply is
required on a separate 20-ampere
circuit, fused on both sides of the line.
A time-delay fuse or circuit breaker is
recommended.
The fuse must be sized per local codes in
accordance with the electrical rating of the
appliance specified on the model/serial rating
plate located on the bottom of the
cooktop
or grill
burner box.
El Wire sizes and connections must
n
conform to the requirements of the
National Electrical Code, ANSVNFPA
70 - latest edition**, and all local codes and
ordinances. Wire sizes and connections must
conform with the rating of the appliance.
(DI
Each appliance should be connected
w directly to the fused disconnect (or
circuit breaker) through flexible,
armored or non-metallic sheathed, copper cable.
The flexible, armored cable extending from the
appliance should be connected directly to the
junction box.
El Locate the junction box to allow as
. much slack as possible between the
junction box and the appliance so that
the appliances can be moved if servicing is ever
necessary. Do Not cut the conduit.
El A U.L.-listed, l/2” conduit connector
must be provided at the junction box.
El
A wiring diagram is located in the
. literature package or on the bottom of
the cooktop and grill.
Copies of the standards listed above may be obtained from:
l
* National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269