Electronic Ignition System -
initial lighting and gas flame adjustments.
Cooktop burners use electronic ignitors in place of standing pilots. When the cooktop control knob is turned to the “HI”position, the system creates a spark to light the burner. This sparking continues until the burner has a flame.
HI
115.1Check the operation of the cooktop burners. Push in and turn each
control knob to the “HI”position. The flame should light within 4 seconds.
Check each cooktop burner for proper flame. The small inner cone
should have a very distinct blue flame approximately l/2” long. The outer cone is not as distinct as the inner cone. The “LO”(or simmer) setting of each burner has been factory set to the lowest setting available to provide reliable reignition of the burner. If any burner does not stay lit on the “Lo” setting, contact your KitchenAid dealer for assistance.
1171. If burners do not light properly, turn cooktop control knob to the “OFF”
position. Check that burner cap is in proper position. Check the power to the unit and the circuit breaker or house fuse. Check that gas valves are set to the “ON”position. Repeat Step
16.If a burner does not light at this point, contact a KitchenAid dealer for assistance.
(181. Refer to your “Useand Care Guide” and check the ooeration of the oven
bake element and broil element.
L.P. gas conversion
No attempt shall be made to convert the appliance from the specified gas on the rating plate for use with a different gas without consulting the serving gas supplier. Conversion to L.P. gas requires Kit No. 4175461 available from your KitchenAid dealer. This conversion must be done by a qualified technician. Contact your KitchenAid dealer.