17
3. Use 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifices from the end of the gas valves.
4. Install new 2.34 mm orifices supplied with this kit to the en d
of the gas valve. Use 6 mm socket and wrench or 6 mm nut
driver to tighten.
NOTE: The number 2.34 is stamped on the orifice for
identification.
5. Replace burner by sliding the middle tube (venturi) over the
orifice.
6. Reattach gas burner using 2 screws.
7. Repeat the procedure for each grill burner.
Change the Rotisserie-infrared burner orifice(s)
1. Remove the access cover and screw at the back of the grill
hood with a Phillips screwdriver.
2. Use Phillips screwdriver to remove 2 screws holding the
spider guard to the burner.
3. Use 10 mm wrench to remove the brass orifice located at the
end of the supply pipe.
4. For models with 1 rotisserie burner:
Install 1.9 mm orifice supplied with this kit to the end of the
supply pipe. Use 10 mm wrench to tighten.
For models with 2 rotisserie burners:
Install 1.55 mm orifice supplied with the kit to the end of the
supply pipe. Use 10 mm wrench to tighten.
NOTE: The number 1.9 mm or 1.55 mm is stamped on the
orifice for identification.
5. Replace the spider guard and secure with the 2 screws
removed in Ste p 2.
6. Repeat the procedure for each rear burner.
Change the Side burner orifices
(for models equipped with side burner)
1. Remove the side burner grates.
2. Remove the burner caps. The caps are interlocked to the
burner base. Twist and lift the burner caps to remove.
3. Use 10 mm socket and wrench or 10 mm nut driver to
remove the brass orifices from inside the burner base.
A.Grill burner orifice
A.Grill burner orifice
A.Burner/orifice connection
B.Burner
A. Two screws
A
A
A
B
A
A.Spider guard
B.Two screws
A
B