5
INSTALLATION REQUIREMENTSTools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Supplied
■Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold)
■Natural gas conversion kit with convertible regulator set for 4"
WCP Natural gas (on some models)
■Natural gas conversion kit (on some models)
■Rotisserie motor mounting bracket (on some models)
■Rotisserie motor (on some models)
■Rotisserie forks (on some models)
■Rotisserie spit (on some models)
■Smoker box (on some models)
■2 warming drawer pans (on some models)
■1 single-prong plug/500mAmp transformer assembly for the
rotisserie motor (on some models)
■2 - 1.5V “D” size alkaline batteries (on some models)
■Vinyl grill cover (on some models)
Parts Needed
■20 lb LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
■UL outdoor-rated 120 V extension cord - size 14gau ge/3 wire
(marked 14/3 W-A), 50 foot (15.2 m) maximum length
Location Requirements
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft
areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for freestanding outdoor
grills:
■A minimum of 24" (58 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
■A 24" (58 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie
A 6" (15.2 cm) minimum clearance is needed for the rotisserie
motor.
A grounded, 3-prong outdoor outlet is located on the back of the
grill. See “Electrical Requirements” section.
NOTE: The rotisserie is an accessory on some models. See the
“Assistance or Service” section to order.
■Tape mea su re
■Small, flat-blade screwdriver
■Flat-blade screwdriver
■#2 and #3 Phillips screwdriver
■Level
■Short Phillips screwdriver or a
90° screwdriver with a Phillips
screw bit
■Wrench or pliers
■Pipe wrench
■Scissors or cutting pliers
(to remove tiedowns)
■Noncorrosive leak-
detection solution
WARNING
Explosion Hazard