KitchenAid W10117506B Installation Instructions, Outdoor Sear Burner Installation

INSTALLATION INSTRUCTIONS

Outdoor Sear Burner Installation

WARNING

Excessive Weight Hazard

Use two or more people to move and install built-in sear burner.

Failure to do so can result in back or other injury.

■Unpack sear burner. Remove all packaging materials and remove sear burner from carton.

■Move sear burner close to desired outdoor location.

Make Gas Connection

Natural Gas Use

This installation must conform with local codes and ordinances. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1 - latest edition, or CAN/CGA-B149.1 Natural Gas and Propane installation code.

3.Using a wrench to tighten, connect the gas supply to the sear burner. Use pipe-joint compound on all non-flared male threads. Do not kink or damage the flexible connector when moving the sear burner.

A

B

DC

A. ½" (1,3 cm) sear burner gas pipe

B. New CSA International approved “outdoor” flexible gas supply line

C. Rear of sear burner

1.Place sear burner into outdoor enclosure, but leave enough room in back to connect to gas supply and plug in electrical single-prong plug to sear burner.

WARNING

Explosion Hazard

Use a new CSA International approved “outdoor” gas supply line.

Securely tighten all gas connections.

Failure to do so can result in death, explosion, or fire.

2.A combination of pipe fittings must be used to connect the sear burner to the existing gas line. If local codes permit, use an outdoor flexible stainless steel tubing gas connector, design-certified by CSA International, to connect the sear burner to the rigid gas supply line. A ⁵⁄₈" diameter line is recommended. Pipe-joint compounds suitable for use with Natural gas must be used. Do not use TEFLON®† tape.

D. To Natural gas supply

4.Open the manual shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.

A

B

A. Closed valve

B. Open valve

5.Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

Plug in Sear Burner

1.This built-in outdoor sear burner comes with a 5,000 mAmp power transformer plug assembly for the igniter system. Plug in the single-prong plug in the receptacle on the lower left- hand side of the sear burner.

A

A. Single-prong plug

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

8