INSTALLATION INSTRUCTIONS
Remove and Replace Freezer Drawer Front
Depending on the width of your door opening, it may be necessary to remove the freezer drawer front to move the refrigerator into your home.
IMPORTANT:
■If the refrigerator was previously installed and you are moving it out of the home, before you begin, turn the refrigerator control OFF, and unplug the refrigerator or disconnect power. Remove food from the freezer drawer.
■Two people may be required to remove and replace the freezer drawer front.
Tool Needed: ¹⁄₄" hex driver
Remove Drawer Front
1.Open the freezer drawer to its full extension.
2.Remove the two screws at the top, inside the drawer front (one on the
3.Lift up on the drawer front to release the plastic studs from the drawer glide bracket slots.
A
A. Drawer glide bracket slots
4.Slide the drawer glides back into the freezer.
Replace Drawer Front
1.Pull out the freezer drawer glides to their full extension.
2.Holding the drawer front by its sides, align the two plastic studs, located at the bottom, inside the drawer front, with the drawer glide bracket slots.
NOTE: It helps if one person holds the drawer glides steady while another person aligns the drawer front and inserts the studs into the slots.
A
B
A. Drawer front screw
B. Drawer front plastic stud
3.Replace and tighten the two screws at the top of the drawer front (one on the
Final Steps
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
1.Plug into a grounded 3 prong outlet.
2.Reset the controls. See “Using the Control(s).”
3.Return all removable door parts to doors and the food to refrigerator.
9
