KLH KC-120ST owner manual Using the AUX input

4.The KC-120ST will fully charge an iPod when the iPod is mounted in the dock and the KC-120ST’s adapter is plugged into an AC outlet.

5.To listen to your iPod, place it in the dock and press the PLAY/PAUSE (8) button.

6.Press the PLAY/PAUSE button (8) again to stop and resume playback.

7.Press the TUNING UP/DOWN/SKIP buttons (7) to change tracks.

8.Press and hold either of the TUNING UP/DOWN/SKIP buttons

(7) to quickly move to a point in a recording that you want to begin listening from. Release the button when the desired point is located.

Using the AUX input (21)

1.Activate the AUX input by selecting AUX with the SOURCE button (10).

2.Any device that has a standard 3.5 mm (1/8 inch) headphone jack can be played through the KC-120ST. Use the supplied 3.5 mm to 3.5 mm stereo interconnect cable to connect the device’s headphone jack to the AUX input on the back of the KC-120ST. Activate the AUX input by selecting AUX with the SOURCE button (10).

3.Volume can be controlled from the external device or from the KC-120ST. Normally, the volume of the external device should be set to approximately half of maximum and the listening volume controlled from the KC-120ST. If you notice distortion at low volume, turn down the volume on the external device.

4.Laptop computers, Portable DVD, CD, MP3, Tape players, and hand-held TVs are ideal devices to connect via the AUX input.

Room Temperature and Humidity are displayed in the main window (12). When the humidity is below 40% the display will show “LO”. When it is above 90%, it will show “HI”. Likewise, the display will show “LO” when the temperature is below 40 degrees, and “HI” when the temperature is above 110 degrees.

User notes: