21
Settings menu
Audio: allows adjustments to the volume and mute, and turns the projector’s startup Chime on and off.
Sources: allows you to assign a particular input to a specific source key on the remote. Also allows selection of a default Startup Source and enables or disables Autosource and RGB Video.
Sources>Startup Source: this determines which source the projector checks for first for active video during
Sources>Autosource: When Autosource is not checked, the projector defaults to the source selected in Startup Source. If no source is found, a blank screen displays. When Autosource is checked, Startup Source determines which source the projector defaults to at
Sources>RGB Video: check this box if you are using a DVD player with RGB output.
System>Rear: reverses the image so you can project from behind a translucent screen.
Ceiling: turns the image upside down for
Auto Ceiling: automatically senses when the projector is inverted and turns the image upside down. This is “On” by default.
Auto Power: When Auto Power is checked, the projector automatically goes into the startup state after the projector is powered on. This allows control of ceiling mounted projectors with a wall power switch.
Display Messages: displays status messages (such as “Searching” or “Mute”) in the
Power Save: automatically turns
the lamp off after no signals are detected for five minutes. After three additional minutes with no signal, the projector powers down. If an active signal is received before the projector powers down, the image will be displayed.
Screen Trigger: turns on the
Backlight: allows you to turn off the backlighting on the keypad.
