Wall Mount Installation

***This installation only applied with the purchase of an optional duct cover:

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.

Decide the location of the venting pipe from the hood to the outside. Refer to Figure 9.

A straight, short venting run will allow the hood to perform more efficiently.

Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood.

Use duct tape to seal the joints between pipe sections.

If necessary, prepare back wall frame with cross framing lumber for secure installation.

Using references on Table 2 and measurements on page 16-17, decide the level of the lumber. Refer to Figure 10.

•Temporarily wire the hood to test for proper operation before installing.

•Important: Peel protective film off the hood and the duct cover (if any).

•Attach ducting transition to hood exhaust with ten (3/16” x 3/8”) screws (included). Refer to Figure 11.

•If necessary, attach two rubber stands (included) with adhesive tape (included) to the back corners of the hood.

•Use eight (3/16” x 3/8”) screws (included) to attach the two hood-mounting brackets (included) to the back of the hood. Refer to Figure 12.

Figure 9

Figure 10

Figure 11

Figure 12

Kobe Range Hoods CH0330SQB, CH0348SQB, CH0336SQB, CH0342SQB Wall Mount Installation