Kodak DC210+ manual 6ROXWLRQ, 3UREOHP

3UREOHP	&DXVH	6ROXWLRQ
Picture is too dark.	Flash is not on or	Turn on the flash. Refer to “Flash” in
	did not go off.	Chapter 3.
	The subject is too	Move so there is no more than 10 ft (3 m)
	far away from the	between the camera and the subject.
	flash.
	The subject is in	Change your position so the light is not
	front of a bright	behind the subject.
	light.
Picture is too light.	The flash is not	Change to automatic flash. Refer to
	needed.	“Flash” in Chapter 3.
	The subject was too	Move so there is at least 1.6 ft (0.5 m)
	close when you	between the camera and the subject.
	used the flash.
	The light sensor is	Hold the camera so your hands or other
	covered.	objects do not cover the light sensor.
Stored pictures are	The memory card	Make sure the Ready light is not blink-
damaged.	was removed when	ing before removing the memory card.
	the Ready light was
	blinking.

Pictures remaining	The image resolu-
number does not	tion does not take
decrease.	up sufficient space
	to decrease the pic-
	ture remaining
	number.

The camera is operating normally. Con- tinue taking pictures.

Picture is not clear.	The lens is dirty.	Clean the lens. Refer to “Caring for the
		Camera” in Chapter 2.

The subject was too close when you took the picture.

Move so that there is at least 1.6 ft (0.5 m) between the camera and the subject. Stand at least 8 in (20 cm) away for close-ups and at least 3.28 ft (1 m) for telephoto pictures.

	Subject or camera	Hold camera steady during picture tak-
	moved during pic-	ing until after the flash (or the second
	ture taking.	flash if the camera flash is set for red-
		eye reduction).
Templates do not	The memory card	Only the original memory card contains
work.	may not contain the	templates. Templates are lost when the
	templates.	memory card is formatted. Instructions
		for replacing the templates can be
		found on the Kodak Web site at
		www.kodak.com.

Troubleshooting 7-3