Kohler K-1220-AC, K-1215-AC, K-1200-AC manual Height Adjustment, Secure Whirlpool, Install Plumbing

B. HEIGHT ADJUSTMENT

NOTICE: Steps B. and C. are necessary for making your Kohler Whirlpool operate more quietly.

If the subfloor is level, no adjustment is necessary; proceed to Step C. If the subfloor is not level, shim beneath pump bracket (plywood is recommended). Do not change the elevation of the pump relative to the whirlpool bath since this may affect performance. Use a 5 x 7 (minimum) piece of plywood.

C. SECURE WHIRLPOOL

Using four 1/4” x 1” lag screws, secure pump bracket to subfloor. Predrilling is recommended.

CAUTION: Risk of product damage. Do not use the piping or pump for structural support or positioning of whirlpools.

Use a 1/2” wrench to remove the long bolt securing the bracket to the bath.

D. INSTALL PLUMBING

CAUTION: Risk of damage to whirlpool bottom and subfloor. Ensure watertight seal on bath drain connections.

1.When whirlpool is securely positioned, connect drain into trap. An access panel will simplify future maintenance.

2.Install the faucet valving and spout tee. If faucets are deck-mounted, the deck must be finished before handle trim and spout can be installed. Open hot and cold valves and check all supply connections for leaks.

3.Run water in whirlpool and check drain connection for leaks.

Drainage

Shim if necessary, using 5” x 7” (minimum)

	Bracket
Spacer
Plywood	Bolt
(if required)
Lag Screw

Connect Here

106548-CA(9437) 16 Kohler Co., Kohler WI