1.Insert the utility diskette (described in the packing list) into your floppy disk drive.
2.At the DOS prompt [C:>], type [A: INSTALL] then press [Enter].
3.Type in the [Source Disk Driver] (type A if it’s in A drive)
4.At the prompt [Now Connect COM Port:], type your COM port number and press [enter].
5.At the prompt [Install Windows Directory:], type the directory in which Windows is installed. Press [Enter].
6.At the prompt [Do You Want Right Button Mode (Y/N):], type [N] (DOS doesn not support right button mode). Press [Enter].
7.At the prompt [Do You Want To Use Another Mouse(Y/N):], type [N] (if your mouse is not MS compatible type, than type [Y] and type the directory of your mouse driver). Press [Enter].
8.After the line “Now Installing INTC Touch Screen Driver” appears, press [Enter].
9.Reboot your PC.
10.After your PC is rebooted, you can start the MKSCR (screen alignment) program.
11.Change your directory to INTC by typing [cd INTC] at prompt [C:\]
12.Type [MKSCR 640 480] at the prompt [C:\INTC].**
13.Following the instructions on your screen. Touch each point gently without dragging your finger on the touch panel.
14.After you touch the last point, [OK] will appear. Touch the [OK] button on the touch panel to exit the MKSCR program. (if nothing happens when you touch the [OK] button, then the touch panel is not correctly aligned to your monitor. Then press the [ESC] key; this will return you to step 13). Your Onetouch touchscreen is now ready to use.
25