Operation / Remote Control / Troubleshooting
Disconnection
•Remove the USB plug of the USB audio storage medium completely from the USB port do.
Or
•Press the SD / MMC in the SD and MMC port dn in order to unlock it.
•Remove the SD / MMC from the SD and MMC port dn.
LRemote Control
Tip!
Familiarise yourself with use of the similar buttons on the remote control (see Fig. F). Please see the layout of the control panel 1for the functions. Ensure that the front edge of the remote control is pointing in the direction of the sensor 3of the re- mote control 1.
• Please note that the AF function only works with ther AF button 8on the control panel 1.
• Please also note the modified procedure for:
Adjusting the Volume
•Increase the volume by pressing the VOL+ button gt.
•Reduce the volume by pressing the VOL- button hm.
Inserting the Battery
•Press the unlock button ipand remove the battery holder iofrom the battery compart- ment in(see Fig. G).
•Insert a lithium battery of type CR2025, 3 V DC into the battery holder ioin such a way that the side marked with a “+” is facing upwards. Then push the battery holder iointo the battery compartment inuntil it distinctly locks into place.
LTroubleshooting
EFault e Cause E Correction
EThe device cannot be switched on and / or
[ERROR] appears in the display window 9. The connections of the 12 V DC power supply
are faulty.
ECheck that the wiring of the device is correct (see the section on „Connecting to the Vehicle‘s 12 V DC Power Supply“). Then press the RESET button drwith the tip of the ballpoint pen.
Or
The 10 A f lflat blade fuse in the flat blade fuse socket euis broken.
EReplace the broken flat blade fuse with a new 10 A flat blade fuse. Then press the RESET button drwith the tip of the ballpoint pen.
Or
A 15 A fuse of the fuse holder of the 12 V DC power supply is broken.
EReplace the broken fuse with a new 15 A fuse. Then press the RESET button drwith the tip of the ballpoint pen. If the fuse is broken again, check that the wiring is correct.
Or
The device is broken.
EPlease contact the service centre for your country (see guarantee card).
EThe device cannot be operated.
The control panel 1is wrongly connected.
EEnsure that the control panel 1is correctly connected (see the section on attaching the control panel).
Or
The battery of the remote control is flat.
EReplace the used battery with a new lithium battery of type CR2025, 3 V DC.
Or
The sensors 3of the control panel 1and / or remote control may be dirty.
EClean the sensor 3of the control panel 1or the remote control if necessary.
Or
The device is broken.
EPlease contact the service centre for your country (see guarantee card).
EThe stored stations do not remain stored if the control panel is removed or the engine turned off.
The connections for 12 V constant current fnand 12 volt ignition current fphave been mixed up
GB/IE
21
KH2391_Content_UK.indd 21
05.09.2006 14:49:18 Uhr
