Kramer Electronics user manual Configuring the FC-1ETHN via its Ethernet port

Configuring the FC-1ETHN Ethernet Controller

6.2 Configuring the FC-1ETHN via its ETHERNET port

You can configure the FC-1ETHNvia its ETHERNET port.

To configure the FC-1ETHNvia ETHERNET, do the following:

1.Connect the ETHERNET port of the FC-1ETHNto the LAN port on your PC, via a crossover cable with RJ-45 connectors, as Table 4 defines:

Table 4: Crossover Cable RJ-45 PINOUT

Side 1

PIN	Wire Color
1	White-orange
2	Orange
3	White-green
4	Blue
5	White-blue
6	Green
7	White-brown
8	Brown

Side 2

PIN	Wire Color
1	White-green
2	Green
3	White-orange
4	Blue
5	White-blue
6	Orange
7	White-brown
8	Brown

If connecting the ETHERNET port of the FC-1ETHNto the LAN port on a network hub or network router, use a straight-through cable with RJ-45 connectors, as Table 5 defines:

Table 5: Straight-through Cable RJ-45 PINOUT

Side 1

PIN	Wire Color
1	White-orange
2	Orange
3	White-green
4	Blue
5	White-blue
6	Green
7	White-brown
8	Brown

Side 2

PIN	Wire Color
1	White-orange
2	Orange
3	White-green
4	Blue
5	White-blue
6	Green
7	White-brown
8	Brown

2.Run the Kramer Configuration Manager software (see section 5.1) and choose the LAN port (see Figure 2).

3.Click the Search button (or the Action menu’s, Search Board command). The MAC Address for the found “FC-1ETHN” appears in the Device List.

4.Change the settings and then click the Setting button (or the Action menu’s, Setting command) to apply the settings.

Note: be aware that this will alter the IP settings in the FC-1ETHN.

8 KRAMER ELECTRONICS, LTD.