Kramer Electronics user manual Your VP-727T Presentation Switcher Control Panel

Your VP-727T Presentation Switcher Control Panel

￿￿Enables special effect transitions between two sources via a robust T-bar (used for manual control of transition speeds). Alternatively, the effect can be implemented via a TAKE button, with a potentiometer to set the transition speed

￿￿Features single button access to all inputs1—both for the Preview and for the Program output—and the buttons have removable transparent caps to allow labeling

￿￿Features dedicated single button actions for special effect selection, immediate freezing and blanking, PIP display, and the choice of wipe direction

￿￿Has the user menu—conveniently located on the VP-727Tpanel—for complete control of the VP-727via its Preview OSD

￿￿Consol can be simultaneously connected to up to four VP-727machines. Control communication is via the RS-485 port, thus allowing the panel to be located more than 1km from each VP-727

￿￿Has an RS-232 port for field upgrading of its firmware

￿￿With its angled faceplate, may be used freestanding on a table, or mounted in a desktop or in a 19” rack (when your switcher is rack-mounted near to the source devices, you can conveniently place the VP-727Ton a table or desk away from the equipment rack)

￿￿Has a gooseneck lamp (included) that can be plugged into the consol for use in low lighting environments

￿￿Is powered by a 12V DC source

To achieve the best performance:

￿￿Connect only good quality connection cables

￿￿Avoid interference from neighboring electrical appliances, make sure not to block the ventilation holes and position your VP-727Taway from moisture, excessive sunlight and dust. Be sure to position it straight in the correct horizontal position on the table, desk or rack

Caution – No operator-serviceable parts inside unit.

Warning – Use only the Kramer Electronics input power wall adapter that is provided with this unit2.

Warning – Disconnect power and unplug unit from wall before installing or removing device or servicing unit.

4Your VP-727T Presentation Switcher Control Panel

Figure 1 and Table 1 define the front panel of the VP-727T:

1 Has two sets of input buttons: one that routes the input to the "PROGRAM" output and the other that routes to the "PREVIEW" output

2 For example: model number AD2512C, part number 2535-000251

3