Kramer Electronics vs-48hdcpx1 5.1 Connecting to the VS-48HDCPxl via RS-232

1 30

VS-48HDCPxl - Connecting the VS-48HDCPxl

Figure 3: Connecting the VS-48HDCPxl 4x8 DVI Matrix Switcher

5.1 Connecting to the VS-48HDCPxl via RS-232

You can connect to the VS-48HDCPxl via an RS-232 connection using, for

example, a PC. Note that a null-modem adapter/connection is not required.

To connect to the VS-48HDCPxl via RS-232:

 Connect the RS-232 9-pin D-sub rear panel port on the VS-48HDCPxl unit

via a 9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin

5 need to be connected) to the RS-232 9-pin D-sub port on your PC

Contents

Main USE R MAN UAL Page Page 1 Introduction 2 Getting Started ! 2.1 Achieving the Best Performance 2.2 Safety Instructions ! 2.3 Recycling Kramer Products 3 Overview 3.1 Defining the VS-48HDCPxl 4x8 DVI Matrix Switcher Page Page 3.2 Using the IR Transmitter 4 Installing in a Rack 5 Connecting the VS-48HDCPxl 5.1 Connecting to the VS-48HDCPxl via RS-232 5.2 Operating via Ethernet i 5.2.1 Connecting the Ethernet Port directly to a PC Page Page 15 5.2.2 Connecting the Ethernet Port via a Network Hub or Switch 5.2.3 Control Configuration via the Ethernet Port 6 Operating the VS-48HDCPxl 4x8 DVI Matrix Switcher 6.1 Routing Inputs to Outputs 6.2 Disconnecting the Outputs 6.3 Storing and Recalling a Setup Page 6.4 Acquiring the EDID 6.4.1 Acquiring an EDID from a Single Connected Output 6.4.2 Acquiring an EDID from Several Sets of Inputs and Outputs 19 6.4.3 Acquiring the Default EDID 6.5 Locking and Unlocking the Front Panel 6.6 Resetting the Ethernet Configuration to Default Values 6.7 Controlling Configuration via the Ethernet Port 6.8 Firmware Upgrade 7 Technical Specifications 8 Default Communication Parameters 9 Kramer Protocol 2000 i 24 VS-48HDCPxl - Kramer Protocol 2000 Input Description Definition for Specific Instruction Page Page !